Pre-printing 3 dabs - 3D Fabrication - Dallas Makerspace Talk

I’m sure most of you have watched the polyprinters start a print. They begin by preheating the extruder and then go to the front left corner of the bed to deposit 3 little dots to prime the extruder. My question is: Is this part of the G-code pre-processor script, or is it a function of the KISSlicer software? I’d like to do something similar for my Ender 3 and using PrusaSlicer, but I’m lazy and don’t want to figure out how to do it myself. 🙂 @frank_lima @AndrewLeCody

The State of 3D Printing and Scanning After CES 2014: The Push For Mainstreaming Begins - Make

UPDATED April 2nd - From Design to Mass 3D printing of Medical Shields in Three Days - Original Prusa 3D Printers

Happenings — UnSmoke Systems Artspace

Pre-printing 3 dabs - 3D Fabrication - Dallas Makerspace Talk

EHS The Magazine: Spring 2023 by Episcopal High School - Issuu

Dallas Makerspace Talk

Top 10 Best 3D Printing in Downey, CA - October 2023 - Yelp

Dallas Innovates 2023 by DALLAS NEXT - Issuu

3D Printing for Young Makers

Tested - Hands-On with Shaper Origin Handheld CNC Router! : r/gadgets

Looking for a pattern - 3D Fabrication - Dallas Makerspace Talk