When start a print the z axis goes up indefinately after homing

Hello, I am having issues starting a print on my duet wifi. I have converted my prusa mk2 to use the duet wifi and I believe i have everything set up well. I have perform mesh leveling with the pinda probe and all the axis move in the direction i expect f

Z-Axis too high at start of print - but completely fine for leveling. : r/ender3v2

This is Why 3D Printing Is Easier Than You Think!

How to fix the error model out of print range – Tiertime Help Center

Lineage barcoding in mice with homing CRISPR

3D Printed SERS-Active Thin-Film Substrates Used to Quantify Levels of the Genotoxic Isothiazolinone

Full Lightburn Control Guide - Snapmaker 2.0 - Snapmaker: where creation happens

Replacing the Z axis limit switch on Cetus MK3 – Tiertime Help Center

Zaber ASCII Protocol Manual - Zaber

My z axis starts at a different position every time I print. Before I order the part is that a problem with a bad switch? Or maybe Octoprint doing something weird?

How to Install the SKR Mini E3 Board (Ender-3) - Let's Print 3D