What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum

The original hot end ended up getting bent (don’t know how, but it did). I replaced it with the included replacement. I did a calibration and everything looked fine. I went to print a simple model on extra fine 0.08mm on the BBL textured PEI plate (as see in the pic) with Overture PETG. As you can see, the nozzle tip gouged the plate and broke off and ended up bending the hot end. What would have caused this to happen? Did I miss a step in the installation of the replacement hot end? Is t

Bambu Lab X1 Carbon Combo Review - The Tesla of 3D printers

CNX-Software] - Bambu Lab X1 – A color 3D Printer with LIDAR and

Creality K1 & K1 Max FDM (Bambu Lab X1 & P1P competition)

My V2 and Bamboo lab X1 Carbon

P1S joins the fleet : r/BambuLab

Bambu Labs X1 Carbon

Bambu Lab X1 Carbon: Info & Discussion (SRO) - Esk8 Electronics

Bambu Lab general thread - X1 and P1 series

Prusa MK3S+ vs Bambu Lab X1 carbon - Page 5 – General discussion